• 2013-2016 Dodge Dart  2.0L ECU Flash (ECU Included)

Q&A

There are no questions for this product.

The time has finally come for what Dart owners all over the world with the 2.0 engine have been waiting for, a tune that increases performance and throttle response while maintaining 100% engine reliability.  As we all know, the Dart was in dire need of more mph and better throttle response. That is where MoPower Calibrations steps in and makes things happen!

MoPower Calibrations has been hard at work developing a calibration for the Dodge Dart 2.0L Automatic and Manual for a long time now. With no tuning solution available there was no choice but to reverse engineer the factory calibration file ourselves and map the parameters needed. Dozens of hours went into disassembling the code and building a calibration that was consistent on the dyno as well as the street.

With the massive amount of time invested we am proud to present: The MoPower Calibrations Dart 2.0 engine Stage 1 tune! A list of the features included in our calibration can be seen below as well as a copy of the dyno sheet. Note that low and mid range gains are as high as 15-18 whp which is really where you feel gains on the street not to mention the 7-10whp peak gain.


* Odometer Might Blink, This is normal when a replacement ECU is flashed on the bench. A Proxy Learn is needed to stop the blinking.

* Please note that the development was done on the automatic transmission and we fully expect gains to be 5-8% higher with a manual.

 

Stage 1 Features include:

1. Modified Torque Management

2. Modified the Electronic Throttle Control (Drive by Wire)

3. Calibrated Spark tables to maximize Premium Pump gas

4. No speed limiter

5. Modified Knock algorithm

6. Increased Intake air flow clips

7. Modified ECU algorithm for long tube header

* When ordering this calibration we require that you ship us a core ECU that we can flash and mail back.

91+ Octane Fuel Required

MoPower Calibrations are sold for off-road use only. All performance Calibrations and Engine Control Units installed are at the customers own risk. MoPower Calibrations or www.mo-power.com holds no responsibility either implied or otherwise for mechanical, electrical or other failure when using any aftermarket performance products from MoPower Calibrations. Items sold for off-road use only are illegal in many states and provinces and are intended for racing vehicles which may never be used on a public road or highway. Not for sale or use in the State of California.

Write a review

Please login or register to review

2013-2016 Dodge Dart 2.0L ECU Flash (ECU Included)

  • Brands Dodge
  • Product Code: DART-13-20L
  • Availability: In Stock
  • $499.99

  • Ex Tax: $499.99

Available Options


Related Products

Dodge Dart Security SKIM Key Delete

Dodge Dart Security SKIM Key Delete

Dodge SKIM (Sentry Key Immobilizer Module) Disable / Reset Did you recently replace a PCM/ECU only to find that the engine started then died, even after the computer was properly reprogrammed? If so, you may also have a bad SKIM module which would cause the vehicle to not start. This service is..

$149.99 Ex Tax: $149.99

Dodge Dart VIN Flash Reprogram

Dodge Dart VIN Flash Reprogram

Just need an ECU re-flashed with your specific Vehicle Identification Number (VIN)? We can handle it.By sending your ECU to us, we can flash your VIN into the ECU. The proper VIN ensures that all factory security measures function as they should and the vehicle starts and operates normally.Contact u..

$79.99 Ex Tax: $79.99

2013-2016 Dodge Dart  2.0L ECU Flash (Tune Only)

2013-2016 Dodge Dart 2.0L ECU Flash (Tune Only)

The time has finally come for what Dart owners all over the world with the 2.0 engine have been waiting for, a tune that increases performance and throttle response while maintaining 100% engine reliability.  As we all know, the Dart was in dire need of more mph and better throttle response. Th..

$399.99 Ex Tax: $399.99

Tags: Dodge, Dart, Tuning, 2.0l, Stage 1, Core